Automatic traumatic gun P226T TK-pro works on the principle of a free shutter. The accuracy of shooting with a 10 × 28 caliber cartridge is quite good - about 10 cm by 6 meters. The P226T TK P magazine holds 10 rounds of ammunition. The gun has a wear-resistant terracotta coating, the barrel length is 112 mm. The length of the pistol itself reaches 196 mm, the height is 140 mm, the thickness of the P226T TK-pro is 38 mm. The mass of the gun without cartridges is 802 gr.
History of creation
The P226T TK P 10 × 28 pistol is produced by the Izhevsk firm Tekhkrim. This model was a novelty of 2014, it has a noticeable external similarity with one of the well-known models of the modern short-barreled weapon - with a self-loading pistol from Germany Sig Sauer P226 9x19 caliber. The second, in turn, has been in demand since the early 80s and is used in the armies of several countries - Egypt, Israel, New Zealand, and the USA.
P226T TK-P pistol device
Its design consists of a double-action trigger type trigger. There is a slight overlap in the barrel, which should prevent a shot from using a solid bullet. A weakening groove is located on the top of the barrel; it is a groove for the locking protrusion in the bolt, which in turn should rest against the groove edge. In this case, the barrel is not removed from the gate.
The design allows you to fix in the front of the bottom LCC or tactical flashlight using the weaver bar. The frame is made of a light alloy (carbon fiber), and USM, bolt-casing, barrel, levers and guides of the bolt-casing - from gun steel. To prevent the illegal "tuning" of a pistol in combat, the barrel of the traumatic pistol P226T TK P is made non-removable. The lever for the slide delay is located in the left side of the frame, above the latch and the handle of the magazine. The safety lever is placed directly in front of it to smoothly pull the trigger from a combat platoon, it increases the safety of the weapon, when compared with the manual manual control of a traditional flag guard. The shutter-housing blocking lever is located at the top of the trigger guard. The shutter-casing has side edges with a large inclined notch, which, because of its large area, can be conveniently controlled by the weapon, bringing the cartridge into the chamber when charging.
Special attention should be paid to the ergonomics of the P226T TK P pistol grip. The magazine latch is located at the base on the left side of the trigger guard. P226T TK P 10 × 28 gun aiming devices consist of unregulated front sight and rear sight with white contrast inserts. Rear wing mounted on the gate in a transverse groove of the type "Dovetail".
