Radio relay station R-419 L1 review TTX

Purpose: TsRRS R-419 L1 is designed to organize independent radio relay communication lines, as well as to tap off channels from multichannel radio relay, tropospheric and wire communication lines.

The station provides work on linking lines of 6 channels of PM equipment of the P-330-6 with the ability to receive the P-340 GMN equipment on the PM channels on communication lines up to 120 km long in the range 390-645 MHz, and in digital modes on communication lines up to 400 km in the range of 390-645 MHz and up to 1500 km in the range of 1550-1850 MHz.

Work on the radio relay station P-419 L1 in the terminal and relay modes

At the station, prepared for work in analog mode

  1. Turn on the station and check for power;
  2. check the work of both half-sets of the section "for yourself";
  3. make electrical measurements of parameters of connecting lines;
  4. get in touch with the correspondent with two semi-sets in terminal mode, measure the stock of the HF level;
  5. adjust the receiving levels of the group paths and the residual attenuation of the PM channels;
  6. measure the frequency response of the residual attenuation of the two PM channels of each half-set, the noise level in the channels, estimate the noise saturation of the channels and pass them to the specialized equipment for classifying or cross;
  7. put the station in the relay mode and make sure that the connection is passing;
  8. make the necessary entries in the hardware log.

At the station, prepared for operation in digital mode

  1. Turn on the station and check for power;
  2. check the work of both half-sets of the section "for yourself";
  3. make electrical measurements of parameters of connecting lines;
  4. get in touch with the correspondent with two semi-sets in terminal mode, measure the stock of the HF level;
  5. check the status of the receiving paths and the quality of communication;
  6. pass digital channels to the hardware for classifying or cross;
  7. put the station in the relay mode and make sure that the connection is passing;
  8. make the necessary entries in the hardware log.

Work is rated

EvaluationWork time, min
For soldiers and sergeants of military service (at the end of the period of service)For contract servicemen
1st2nd
In analog mode
Fine211918
Good232019
Satisfactorily242120
In digital mode
Fine191716
Good211817
Satisfactorily221918

Technical Training Standards

Item numberThe name of the standardScope of workEvaluationTime
97aPreparation for radio relay station Р-419 Л1 in analog modePrepare the station for inclusion. Turn on the station to work in digital mode. Check the operation of both semi-sets "for themselves" in accordance with the instruction manual.Fine6
Good8
Satisfactorily10
99aPreparation for operation of the radio-relay station R-419 L1 in digital modePrepare the station for inclusion. Turn on the station to work in digital mode. Check the operation of both semi-sets "for themselves" in accordance with the instruction manual.Fine6
Good8
Satisfactorily10

Technical characteristics of the radio relay station

Frequency range, MHz390; 645/1550; 1850Minimum spacing between transmit and receive frequencies
The length of the interval, kmup to 40-45390-645 MHz range
Crew4range 1550-1850 MHz
Time of adjustment of operating frequency, s2Antenna orientation: Remote, electrically driven in azimuth and elevation
Operation modecontinuous

Watch the video: Car Stereo Troubleshooting Fuse Basic (November 2024).